Water Softener Installation in Elgin: Code, Sizing and Which Taps
Water softener installation in Elgin is a plumbing hookup governed by the state code, sized for water the city has already partly softened. A careful installer settles three things before quoting: the drain, the size and the taps.
Illinois code requires a softener drain to discharge through an air gap at least twice the pipe diameter and never under 2 inches, and many units need a double check valve on the supply (77 Ill. Adm. Code 890.760). On Elgin's 7.9-grain water a single tank usually suffices. Fixr (2025) puts single-tank installs at $650–$1,500.

What does Illinois require of a softener hookup?
Two things in the state plumbing code. First, wash and rinse water from the softener must leave through a vertical air gap at least twice the diameter of the drain pipe and not less than 2 inches, so drain water can never be siphoned back. Second, a softener that draws brine by a venturi needs no backflow preventer on its supply line, but all other types need a double check valve backflow preventer assembly on the inlet (77 Ill. Adm. Code 890.760). Separately, the state plumbing license law excludes the business of installing and servicing softening equipment from its definition of plumbing (225 ILCS 320/2). Ask Elgin's permit office whether a permit applies to your job.
How big a softener does Elgin water need?
Smaller than in towns that skip central softening. HomeGuide's sizing formula is daily water use times hardness, and its worked example uses a household drawing 400 gallons a day. At Elgin's 7.9 grains that household removes about 3,160 grains a day; at the 20 grains in HomeGuide's example, 8,000. A single-tank unit that regenerates every few days usually covers the city-water figure. A well at 20-plus grains changes the math entirely, which is why the source matters more than the brand.
Should every tap get softened water?
Not in Elgin. The city's water already measures seven to eight grains and carries about 60 mg/L of sodium before any softening (City of Elgin FAQ; the 2025 report lists 59 ppm). Common choices are to soften only the hot water, or hot plus laundry, and to leave a cold kitchen tap, toilets and hose bibs on city water. That saves salt, limits added sodium, and avoids over-softening older pipes.
Getting ready for the visit
Find the main shut-off and the nearest floor drain or laundry standpipe, check for an outlet, and note whether capped pipes from an old softener are already there. Know whether your bill comes from the City of Elgin or another system. Then compare equipment and labor against the Elgin water softener cost guide.
Questions homeowners ask
Do I need a licensed plumber to install a softener in Illinois?
Illinois's plumbing license law excludes the business of installing and servicing water softening equipment from its definition of plumbing (225 ILCS 320/2). The connection still has to meet the state plumbing code, including the drain air gap and backflow rules in 77 Ill. Adm. Code 890.760. Ask the City of Elgin whether a permit applies.
Describe the water at your house
Write a line or two: city water or a well, the age of the house, a softener that misbehaves, or a worry about old pipes. One independent water treatment specialist who works around Elgin will get in touch.